How to Clean Tennis Shoes With Baking Soda in 5 Easy Steps
Contents
Learn how to clean your tennis shoes with baking soda in 5 easy steps. You’ll be surprised at how easy it is to get your shoes looking new again!
Introduction
It’s no secret that tennis shoes can get pretty dirty, fast. But did you know that you can clean them with something as simple as baking soda? Here’s how:
1. Start by taking your shoes outside and giving them a good shake to remove any loose dirt and debris.
2. Next, mix together a Solution of one part baking soda to two parts water in a bowl.
3. Using a soft cloth or brush, apply the Solution to your shoes and scrub gently.
4. Rinse the shoes off with clean water and allow them to air dry.
5. Once they’re dry, laces and all, you’re done!
What You’ll Need
-1/2 cup baking soda
-1 cup water
-1 teaspoon dish soap
-A soft-bristled brush
Step One: Prep the Shoes
The first step is to prep the shoes. For this, you will need to gather the following materials:
-Tennis shoes
-Baking soda
-Water
-A bowl or bucket
-A toothbrush (optional)
Once you have gathered all of the necessary materials, you can begin prepping the shoes. Start by giving them a good visual inspection. If they are extremely dirty, you may want to pre-treat them with a stain remover. Next, use the toothbrush (if desired) to remove any loose dirt or debris from the surface of the shoes.
After the shoes have been prepped, it is time to move on to the next step.
Step Two: Make the Baking Soda Paste
In a small bowl, mix together 1/2 cup baking soda and 1/4 cup water to form a paste. You can adjust the amount of baking soda and water you use depending on how large or small your shoes are, but this ratio should work for most shoes.
Step Three: Apply the Paste and Let it Sit
Now that you have your paste, it’s time to apply it to your shoes. You can use an old toothbrush to help work the paste into the fabric of your shoes. Make sure to get into all the nooks and crannies, paying special attention to any areas that look particularly dirty. Once the paste is worked in, let it sit for about 15 minutes. This will give the baking soda time to work its magic and break down all the dirt and grime.
Step Four: Rinse the Shoes
Once you’ve scrubbed the shoes with the baking soda paste, it’s time to rinse them off. You can do this with a garden hose, in a sink full of warm water, or even in the shower. If you’re using a garden hose, be sure to hold the shoes at an angle so that the water can run off easily.
If you’re using a sink or shower, let the warm water run over the shoes for a few minutes before gently rubbing them together to help remove any lingering baking soda paste. Once the shoes are rinsed, set them aside to air dry – do not put them in the dryer!
Step Five: Let the Shoes Dry
After you’ve let the shoes sit in the baking soda mixture for at least an hour, it’s time to take them out and let them dry. You can either let them air dry or put them in the dryer on a low heat setting. If you choose to put them in the dryer, make sure to put a towel in with them so they don’t get scratched. Once they’re dry, your shoes will be clean and smell fresh!
