How To Shorten A Tennis Bracelet At Home?
How to Shorten a Tennis Bracelet at Home? – Follow these simple steps and you’ll have your bracelet fitting like new in no time!
Introduction
A tennis bracelet is a piece of jewelry that is worn around the wrist. It is usually made of diamonds or other precious stones. The name “tennis bracelet” comes from the fact that it was first worn by tennis player Chris Evert during a match in 1987. After Evert’s bracelet broke during the match, she asked for a replacement, and thus the term “tennis bracelet” was born.
Tennis bracelets are typically seven to eight inches long, but they can be made shorter or longer to fit any wrist size. If your bracelet is too long, it may get caught on clothing or hair, which can cause it to break. If it is too short, it may be uncomfortable to wear.
There are a few different ways to shorten a tennis bracelet at home. The most common way is to usejewelry pliers to remove links from the bracelet. This method is quick and easy, but it does require some knowledge of how jewelry works. Another way to shorten a tennis bracelet is to knot the excess material into a loop. This method is less permanent than using pliers, but it does not require any special skills or knowledge.
No matter which method you choose, shortening a tennis bracelet at home is a simple process that anyone can do.
What You Will Need
-Tennis bracelet
-Ruler or measuring tape
-Scissors
-Lighter
Instructions:
1. Measure your wrist with a ruler or measuring tape. Add 1/2 inch to that measurement to find out what length bracelet you will need.
2. Cut the tennis bracelet at the spot where you need to make the adjustment using a pair of scissors. Discard the excess piece of bracelet.
3. Use a lighter to sealing the ends of the bracelet by heating up the metal until it’s slightly melted. Wait for it to cool and harden before wearing it again.
Steps to Shorten the Bracelet
If your bracelet is too big and you need to make it smaller, follow these easy steps:
1)Using a pair of needle nose pliers, carefully remove one of the end caps from the bracelet.
2)Remove the desired number of links from the bracelet. For example, if you need to shorten the bracelet by 3 inches, remove 3 links from the bracelet.
3)Replace the end cap that you removed in step 1.
4)Repeat steps 1-3 for the other end of the bracelet.
Conclusion
By following the steps above, you can shorten your tennis bracelet at home without professional help. All you need is a pair of scissors and a Ruler (or a measuring tape). Be sure to take your time and measure twice before cutting to avoid mistakes. With a little bit of effort, you can have your bracelet fitting perfectly in no time!
